Skip to content
Important information regarding Coronavirus (COVID-19): Following government guidance we have reduced our workforce to limit any possible spread of the virus, because of this our delivery times may be slightly longer than usual but please bear with us, we’ll get your orders to you as quickly as possible.
Important information regarding Coronavirus (COVID-19): Following government guidance we have reduced our workforce to limit any possible spread of the virus, because of this our delivery times may be slightly longer than usual but please bear with us, we’ll get your orders to you as quickly as possible.

Super Bright 24w/24v LED Tape 2000k Flame White 5 Metre IP65

£56.38

This is a rare 2000k 'Flame White' LED tape using a premium Epistar chip producing highest possible colour rendering in 90 CRI. Perfect for creating a candle flame effect in bars and restaurants. Supplied in an IP65 silicone sleeve.
ItÕs so easy to install due to its flexible physical size and the 3M adhesive tape on the reverse can be easily concealed. Our range of LED tape has been installed in thousands of locations and we offer one of the most comprehensive ranges of LED strip lighting on the market.
What Makes Our Tape Premium?
Our premium tapes are printed on a thicker 2 oz. PCB to help with heat dissipation and have a high quality chip producing lower light degradation. These tapes come with a strong 300 LSE 3M tape backing and have cables pre-soldered at both ends of the reel. All premium non-waterproof tapes are sold with an unprecendented five year warranty.
Premium tapes are better for long term installations and demanding commercial environments where colour rendering and long lasting brightness is essential. Standard tapes provide a great amount of performance for less cost.

Tech Specs


  • Supplied in 5 metre reels
  • LED Type: 2835 High Brightness Chip
  • Power Consumption: 24w per metre | 120w per reel
  • Lumens: 1550 p/m
  • Voltage: 24v
  • Tape Width: 10mm + 2mm Silicone
  • Colour Temperature: 2000 Kelvins (flame white)
  • Number of LEDs: 120 per metre | 600 per reel
  • Water Ingress Rating: IP65 (splashrproof)
  • Cut points: every 5cm
  • Dimmable: Yes
  • Warranty: 3 Year

How to connect?


LED strip lights are supplied with 15cm of live wires pre-soldered on one end. If you are using one of our Drivers you can order 1 x U2.1FEM to connect with. If you are using one of our Premium Range Drivers you can wire in directly via terminals located on the unit. (With exception to our waterproof premium drivers, which are fully sealed).
How Do I Extend?
You can use our IP65 connector block for our single colour tapes here.
Which profile can I use?
Please note that waterproof tapes do not fit inside all of our aluminium profiles. The shallowest profile that can be used is the 17 x 8mm standard profile. Profiles described as 'Extra Deep' will also house these tapes. Please contact us if you are unsure whether a particular combo will work.
What Driver do I need?
To work out what driver you will need for each length of LED you can simply multiply the wattage of the tape by the length of LED strip you will be using, this will give you the total wattage the LED strip requires, then simply choose a driver which is at least 10% above this figure.
Note that this tape is high-powered and can be a fire hazard unless correctly mounted to a heat dissipating surface such as aluminium. We strongly advise that you seek advice on mounting this tape to ensure it is safe. Installing too much in a small space without ventilation can cause high temperature build up. Ensure heat can escape using one of our recommended extrusions or another heat convecting surface. Email us for more information.