Skip to content
Important information regarding Coronavirus (COVID-19): Following government guidance we have reduced our workforce to limit any possible spread of the virus, because of this our delivery times may be slightly longer than usual but please bear with us, we’ll get your orders to you as quickly as possible.
Important information regarding Coronavirus (COVID-19): Following government guidance we have reduced our workforce to limit any possible spread of the virus, because of this our delivery times may be slightly longer than usual but please bear with us, we’ll get your orders to you as quickly as possible.

Bright Plus 9w 24v LED Tape 2000k Ultra Warm White 5 Metres

£41.00

New slimline LED tape at just 4mm wide. Great for all the tight installation areas and ideal for use with our smallest Micro Aluminium Profile or edge lighting acrylic.
Dimmable via DALI, DMX, ELV, TRIAC and 0-10V methods.
What Makes Our Tape Premium?
Our premium tapes are printed on a thicker 2 oz. PCB to help with heat dissipation and have a high quality chip producing lower light degradation. These tapes come with a strong 300 LSE 3M tape backing and have cables pre-soldered at both ends of the reel. All premium non-waterproof tapes are sold with an unprecedented five year warranty.
Premium tapes are better for long term installations and demanding commercial environments where colour rendering and long lasting brightness is essential. Standard tapes provide a great amount of performance for less cost.


Tech Specs


  • Supplied in 5 metre reels
  • LED Type: 2216 Chip
  • Power Consumption: 9w per metre | 45w per reel
  • Lumens: 630 p/m
  • Voltage: 24v
  • Tape Width: 4mm
  • Colour Temperature: 2000 Kelvins (flame white)
  • Number of LEDs: 120 per metre | 600 per reel
  • Water Ingress Rating: IP20 (non waterproof)
  • Cut points: every 5cm
  • Dimmable: Yes
  • Warranty: 5 Year

How to connect?


LED strip lights are supplied with 15cm of live wires pre-soldered on one end. If you are using one of our Drivers you can order 1 x U2.1FEM to connect with. If you are using one of our Premium Range Drivers you can wire in directly via terminals located on the unit. (With exception to our waterproof premium drivers, which are fully sealed).
What Driver do I need?
To work out what driver you will need for each length of LED you can simply multiply the wattage of the tape by the length of LED strip you will be using, this will give you the total wattage the LED strip requires, then simply choose a driver which is at least 10% above this figure.
For the TL016 tape range the following drivers could be used:


1 metre Ð ORION-15/24V
2 metre Ð ORION-25/24V
3 metre Ð ORION-36/24V
4 metre Ð ORION-50/24V
5 metre Ð ORION-50/24V